White list

How the White list works and how to add addresses to it.

If you have several protected profiles, note that White lists are configured separately for each profile. For more information, see How to configure.

What it is

The White list is a tool that lets you disable filtering for traffic from specific IP addresses or subnets.

Example: with the settings below, the system allows traffic from 203.0.113.10/32 to your resource without checks.

Example settings

When it is useful

The White list is intended for addresses that access your resource externally and must not be blocked under any circumstances. For example:

  • IP addresses of customers, partners, and employees.

  • External integrations and APIs.

  • Monitoring and availability-check systems.

  • Other trusted sources.

How filtering works with a White list

Traffic is filtered according to a defined set of rules—a protected profile. The system blocks suspicious packets and allows the rest to reach your resources.

The White list is built into the filtering rules. If traffic arrives from a source on the list, the system treats it as trusted and allows it without checks.

How to configure

Under Network protection → Protected profiles, check how many protected profiles you have.

List of protected profiles

If there is one profile, add addresses as described below. If there are several profiles, first open the note below.

How do I configure lists for several protected profiles?

A protected profile is a set of traffic filtering rules. When there are several profiles, traffic to different resources is filtered differently.

Each profile protects only the IP addresses or subnets listed next to it in the IPs column:

List of protected resources

Each profile has its own White list. Consider this when configuring it:

  1. Check which resources are assigned to a particular profile.

  2. Add to that profile’s White list the addresses that must have unrestricted access to the specified resources.

If an address must have unrestricted access to all your resources, add it to the White lists of all profiles.

In the management console

  1. Under Network protection → Protected profiles, find the profile for which you need to configure the White list. Select the ellipsis (…) at the end of the row, then choose White list.

    Opening the White list
  2. Select + Add IP address to white list.

    Button for adding an address
  3. In the window that opens, enter an IP address, for example 192.0.2.15/32, or a subnet, for example 192.0.2.0/24. To add several addresses at once, separate them with commas.

    Adding addresses
  4. Select Create. The added addresses appear in the list.

    Example of a White list

If you need to delete an address from the list later, select the trash icon and confirm the action.

Using a remote list

A remote list lets you obtain a list of trusted addresses from a file published on your resource. The system accesses the file over HTTP(S) and retrieves the updated list with GET requests. We set the polling interval based on your requirements; the minimum interval is one minute.

  • Addresses from a remote list do not replace settings made in the management console. The system applies all lists at the same time.

  • If there are several protected profiles, we can configure a shared remote list. You will not need to add addresses to every profile separately, and the list will apply to all resources.

How to configure it:

  1. Publish the list on your resource. Each line must contain one address or subnet.

  2. Allow access to the list for the IP address provided by our support team.

  3. Contact support to enable synchronization.

To delete an address from the White list, remove it from the file on your resource. The system detects the change and no longer treats the address as trusted.